Standard Swedish standard · SS-ISO 2493-2:2011

Paper and board - Determination of bending resistance - Part 2: Taber-type tester (ISO 2493-2:2011, IDT)

Status: Withdrawn

· Replaced by: SS-ISO 2493-2:2020
Buy this standard

Standard Swedish standard · SS-ISO 2493-2:2011

Paper and board - Determination of bending resistance - Part 2: Taber-type tester (ISO 2493-2:2011, IDT)
Subscribe on standards - Read more Dölj
Price: 1 013 SEK
standard ikon pdf

PDF

Price: 1 013 SEK
standard ikon

Paper

Price: 1 620,80 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Preview this standard
Scope
ISO 2493-2:2011 specifies procedures to measure the bending resistance of paper and paperboard.ISO 2493-2:2011 is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.The method is primarily used for papers with a high grammage

Subjects

Paper and board (85.060) Cardboard (85.080.30)


Buy this standard

Standard Swedish standard · SS-ISO 2493-2:2011

Paper and board - Determination of bending resistance - Part 2: Taber-type tester (ISO 2493-2:2011, IDT)
Subscribe on standards - Read more Dölj
Price: 1 013 SEK
standard ikon pdf

PDF

Price: 1 013 SEK
standard ikon

Paper

Price: 1 620,80 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: Svenska institutet för standarder

International title:

Article no: STD-82208

Edition: 1

Approved: 11/21/2011

No of pages: 20

Replaced by: SS-ISO 2493-2:2020